1. Check if the paper thickness is Paper Weight 2 or less.
Yes Go to the next step.
No The problem is likely to be a problem other than the problem described here.
2. Check if the paper is curled downward.
Yes Go to the next step.
No The problem is likely to be a problem other than the problem described here.
3. In [Detailed settings] for custom paper, set 1321: [Correct Paper Curl].
Select "Large" or "Small" depending on the degree of decurling required.
4. Check if the problem of scratching or jamming is resolved.
Yes Finished!
No The problem is likely to be a problem other than the problem described here.
Stitching Missing, Incorrect Stitching Position, Ear-fold, or Misaligned Occurs
Cause:
It may occur when printing on thin paper of 64.0 g/m
2
or less.
Solution:
1. Load the sheets the other way up.
2. In [Detailed settings] for custom paper, select 1321: [Correct Paper Curl], and then
specify [Correction Mode].
To correct curls facing up, specify "U Curl Correction Level: Large" or "U Curl Correction Level:
Small".
To correct curls facing down, specify "П Curl Correction Level: Large" or "П Curl Correction Level:
Small".
3. Print the image. Is the problem resolved?
Yes Finished!
No Contact your service representative.
Finisher/Booklet Finisher
301
To Next Page
Loading...
