• Select "Clear/Special" when using Neon Yellow, Neon Pink, or Invisible Red. Select "Metallic"
when using Gold or Silver.
• Doing this may cause color tones to change.
(b) Adjusting the paper transfer speed
1. If the paper is not registered as custom paper, register the brand of the paper.
2. In [Detailed settings] for the custom paper you are using, select 1341: [Motor Speed],
decrease the value in 02: [Paper Transfer Belt] by 0.1%.
3. Print the image. Has the problem been resolved?
Yes Finished!
No Start over from Step 2. If the problem persists even if you decrease the value to
-0.5, there is no other solution.
• Errors may occur depending on the degree of adjustment and conditions. In such a case, contact
your service representative.
• Decreasing the paper transfer roller speed may cause the image to expand or contract in the
subscanning direction. Such a problem may be resolved by increasing the value for [Image
Magnification] in [Manual Adjustment] in [Adjust image position] on the [Media] hub.
(c) Improving the Operating Environment / Changing the Pape
1. Avoid high temperature and high humidity environments.
2. If paper can be changed, change to non-slippery paper.
3. If throughput can be reduced, select 1237: [Print Speed (Sheet Interval Adj)] in [Detailed
settings] for custom paper, and then decrease the value.
• Reducing throughput can reduce the occurrence of patchy images when printing with special toner
(clear).
Patchy Image (Clear Toner Image)
When printing is performed using the clear toner, patchy images appear where the clear toner overlaps.
4. Image Quality Problem: Full Page
126
To Next Page
Loading...
