15. Print 3 or more A3 sheets. Has the problem been resolved?
Yes Go to the next step.
No Start over from Step 14.
16. Is the toner fusibility within the permissible range?
• The required level of fusibility is as follows
• The printed image does not come off.
• The toner does not come off even if it is lightly rubbed by a nail.
• The toner does not come off even if it is rubbed by the cloth for cleaning the contact
glass.
Yes Finished!
No No further improvement is likely.
• Select "Clear/Special" when using Neon Yellow, Neon Pink, or Invisible Red. Select "Metallic"
when using Gold or Silver.
• When printing on both sides of banner sheets, uneven glossiness is prone to occur because the
temperature of the pressure roller tends to rise due to the long intervals between sheets. This may be
resolved by printing on one side and then manually turning the paper over to print on the reverse
side (manual duplex printing).
• After performing the solution, it is recommended to perform the color calibration of the external
controller.
River Marks (Worm Tracks)
Worm tracks appear because of uneven density when printing is performed on synthetic paper, film
media (transparencies), clear files, and on thin paper in grain direction.
4. Image Quality Problem: Full Page
104
To Next Page
Loading...
