• 1232-34: Fusing Temperature: S: Correct Temp: Pre-Feed: Clear/Special
• 1232-35: Fusing Temperature: S: Correct Temp: Pre-Feed: White
• 1232-36: Fusing Temperature: S: Correct Temp: Pre-Feed: Metallic
High Quality
• 1232-48: Fusing Temperature: BW/FC/FCS: Fuser Setting HQ: Correct Temp: Pre-Feed
• 1232-59: Fusing Temperature: FCS: Fuser Setting HQ: Correct Temp: Pre-Feed: Clear/
Special
• 1232-60: Fusing Temperature: FCS: Fuser Setting HQ: Correct Temp: Pre-Feed: White
• 1232-61: Fusing Temperature: FCS: Fuser Setting HQ: Correct Temp: Pre-Feed: Metallic
• 1232-79: Fusing Temperature: S: Fuser Setting HQ: Correct Temp: Pre-Feed: Clear/Special
• 1232-80: Fusing Temperature: S: Fuser Setting HQ: Correct Temp: Pre-Feed: White
• 1232-81: Fusing Temperature: S: Fuser Setting HQ: Correct Temp: Pre-Feed: Metallic
13. Print 3 or more A3 sheets. Has the problem been resolved?
Yes Finished!
No Go to the next step.
14. Select 1232: [Fusing Temperature] and decrease the temperature setting for the fusing
heat roller by 5°C according to the color mode you wish to use.
Productivity Priority
• 1232-01: Fusing Temperature: BW/FC/FCS: Heat Roller Temp
• 1232-06: Fusing Temperature: FCS: Heat Roller Temp: Clear/Special
• 1232-07: Fusing Temperature: FCS: Heat Roller Temp: White
• 1232-08: Fusing Temperature: FCS: Heat Roller Temp: Metallic
• 1232-26: Fusing Temperature: S: Heat Roller Temp: Clear/Special
• 1232-27: Fusing Temperature: S: Heat Roller Temp: White
• 1232-28: Fusing Temperature: S: Heat Roller Temp: Metallic
High Quality
• 1232-46: Fusing Temperature: BW/FC/FCS: Fuser Setting HQ: Heat Roller Temp
• 1232-51: Fusing Temperature: FCS: Fuser Setting HQ: Heat Roller Temp: Clear/Special
• 1232-52: Fusing Temperature: FCS: Fuser Setting HQ: Heat Roller Temp: White
• 1232-53: Fusing Temperature: FCS: Fuser Setting HQ: Heat Roller Temp: Metallic
• 1232-71: Fusing Temperature: S: Fuser Setting HQ: Heat Roller Temp: Clear/Special
• 1232-72: Fusing Temperature: S: Fuser Setting HQ: Heat Roller Temp: White
• 1232-73: Fusing Temperature: S: Fuser Setting HQ: Heat Roller Temp: Metallic
Uneven Density
103
To Next Page
Loading...
