Yes Proceed to Step 5.
No Go to the next step.
3. Place the curled surface down on a flat surface. Hold the end of the paper and straighten
it in the opposite direction to the curl direction so that the paper is rounded.
4. Check if the curl has been reduced.
Yes Finished!
No Go to the next step.
5. Fanning the paper.
For details, see page 199 "Fanning the Paper".
Yes Finished!
No Go to the next step.
6. Check if the curl has been reduced.
Yes Finished!
No Go to the next step.
7. In [Detailed settings] for custom paper, adjust the fan level in 1351-02: [Fan Level].
8. Check if the curl has been reduced.
Yes Finished!
No If the problem persists, repeat Step 7.
If the problem still persists, feed one sheet of paper at a time.
Horizontal Streaks Occur When Loading a Full-Page, Solid-Fill Sheet
Cause:
Due to the sheets that have been fed, paper dust accumulates, and can come into contact with the
sheets, causing thin scratches parallel to the paper feed direction (horizontal streaks).
This is prone to occur especially when printing full-page solid-fill sheets.
11. Post-Processing Option Troubleshooting
306
To Next Page
Loading...
