4. In [Detailed settings] for the custom paper you are using, select 1341: [Motor Speed],
and then check the present value in 02: [Paper Transfer Belt]. Is it lower than 0.5%?
Yes Go to the next step.
No No further improvement is likely.
5. Increase the value in [Paper Transfer Belt] by 0.1%.
• Errors may occur depending on the degree of adjustment and conditions. In such a case,
contact your service representative.
• Decreasing the paper transfer roller speed may cause the image to expand or contract in the
subscanning direction. Such a problem may be resolved by increasing the value for [Image
Magnification] in [Manual Adjustment] in [Adjust image position] on the [Media] hub.
6. Print the image. Has the problem been resolved?
Yes Finished!
No Start over from Step 5.
If the problem persists even after increasing the value to 0.5%, there is no other
solution.
Paper Transfer Shock Jitter / Shock Jitter (When the Positions of K and S
Toners Have Been Switched)
118mm 118mm
76mm
BK
308mm
1P 2P 3P
1P 2P 3P
266mm
308mm
C
2
1
M0EBIC0101
1. Occurring when entering the paper transfer nip
2. Occurring when exiting from the paper transfer nip
*
Example of occurrence in single-sided printing on A3 size paper at 95PPM
Bands
159
To Next Page
Loading...
