3. In [Detailed settings] for custom paper, select 1239: [Margin] and increase the margin
width by + 0.5 mm.
1104-02: Machine: Image Position: Image Position Gap: Image Position: Side 1: With Feed
1104-04: Machine: Image Position: Image Position Gap: Image Position: Side 2: With Feed
4. Print the image and check if the paper jam has been resolved.
Yes Finished!
No Repeat Step 3 to 4.
If the problem persists even after reaching the upper limit, there is no other solution,
so consider changing the paper.
J048 Appears
"J048" notifies a jam that occurs when the image-scanning (TIM-Mag) unit fails to detect the paper's
image position detection mark (L-mark) correctly.
Notes on the image position detection mark (L-mark)
J048 can be detected when settings are specified as follows.
1. If 1103: [Image Position Feedback Correction] is set to "No Detection Mark" or "Detection
Mark" in [Detailed settings] for custom paper.
If the correction is set to "Off", printing continues without JAM048 occurring. However, image
position correction for handling JAM048 is not executed.
2. If 0301: [Detect JAM048] in Adjustment Settings for Operators is set to [On].
If set to [Off], JAM048 does not appear in a situation where JAM048 occurs during paper
feeding, but paper feeding continues without the image position correction, which uses the
detection unit after fusing.
Cause/Solution:
Cause Solution
Using non-white paper Use white paper.
Incorrect paper weight/thickness setting Specify the paper weight/thickness setting
correctly.
Incorrect paper size setting Specify the paper size setting correctly.
8. Troubles Related to Paper Feeding and Delivery (Main)
254
To Next Page
Loading...
Need help?
General
