• The printed image does not come off.
• The toner does not come off even if it is lightly rubbed by a nail.
• The toner does not come off even if the image is wiped with an optical cloth.
Yes Finished!
No No further improvement is likely.
• Select "Clear/Special" when using Neon Yellow, Neon Pink, or Invisible Red. Select "Metallic"
when using Gold or Silver.
• After performing the solution, it is recommended to perform the color calibration of the external
printer controller.
The Buffer Pass Unit's Fan is Noisy
You can change the buffer pass unit fan activation setting according to the type of paper and operating
environment (ambient temperature).
Use 0303-01: [Buffer Pass Unit Fan Activation Setting] in Adjustment Settings for Operators to set the
fan on or off.
• Depending on the setting, blocking, whereby toner particles on stacked copies form clumps, may
cause the print image to detach. If this happens, set the fan to on.
Cleaning the Buffer Pass Unit
1. If the Buffer Pass Unit is attached, pull out the buffer pass unit and open the guide plates.
Wipe the rubber rollers for the transport rollers with a slightly damp cloth.
M0EBIC0175
1
2
3
4
5
67
8
9
10
11
12
11. Post-Processing Option Troubleshooting
292
To Next Page
Loading...
