Not Stacked Properly (Carbonless Paper of Paper Weight 0/1)
Cause:
The Z-fold support tray was attached to lower the angle against the exit tray and reduce the transport
resistance, but as a result, the jogger could not reach the paper surface to perform alignment in the
direction of the paper width.
The width alignment cannot be performed with the Z-fold support tray attached
1. Stacked sheets
2. Jogger cannot reach the paper surface
The Z-fold support tray's width is too narrow, so both edges of the paper protrude and droop from the
Z-fold support tray. The non-alignment becomes severe especially with long edge feed (LEF) of sheets
with curls on sides in the cross-grain direction.
Range of paper drooping in the direction of the paper width with the Z-fold support tray attached:
1. Drooping part
2. Z-fold support tray
3. A4 LEF stacked paper
11. Post-Processing Option Troubleshooting
296
To Next Page
Loading...
