Ricoh Pro C7500 - Banding in Solid-Fill Areas Printed with Metallic (Gold) Toner

• 1214-06: Paper Transfer Output: FC/FCS: Side 2
• 1214-09: Paper Transfer Output: FCS: Side 1
• 1214-10: Paper Transfer Output: FCS: Side 2
• 1214-13: Paper Transfer Output: S: Side 1: Clear/Special
• 1214-14: Paper Transfer Output: S: Side 1: White
• 1214-15: Paper Transfer Output: S: Side 1: Metallic
• 1214-17: Paper Transfer Output: S: Side 2: Clear/Special
• 1214-18: Paper Transfer Output: S: Side 2: White
• 1214-19: Paper Transfer Output: S: Side 2: Metallic
3. Print the image. Has the problem been resolved?
Yes Finished!
No Go to the next step.
4. In 1214: [Paper Transfer Output], further adjust the values in the applicable settings in
steps of ±1.
5. Print the image and check if there are any problems such as faintness or white spots.
Yes No further improvement is likely.
No Finished!
• Select "Clear/Special" when using Neon Yellow, Neon Pink, or Invisible Red. Select "Metallic"
when using Gold or Silver.
Banding in Solid-Fill Areas Printed with Metallic (Gold) Toner
Cause:
Due to the fluctuations in the speed of the intermediate transfer belt in the paper transfer unit and paper
feed speed fluctuation, toner adhesion fluctuates, causing banding.
Occurrence conditions:
This may occur when printing is performed on thick paper using metallic toner.
This is particularly noticeable with gold toner. It may also occur with silver toner, but is less noticeable
due to its relatively low visibility.
Bands
151