• 1238-02: Fusing Cleaning: FCS/S: Cleaning Interval: Clear/Special
• 1238-03: Fusing Cleaning: FCS/S: Cleaning Interval: White
• 1238-04: Fusing Cleaning: FCS/S: Cleaning Interval: Metallic
11. Print the image. Has the problem been resolved?
Print 20 sheets of the image, then another 10.
Yes Finished!
No Repeat Steps 10 and 11.
If the problem persists, there is no other solution.
• Select "Clear/Special" when using Neon Yellow, Neon Pink, or Invisible Red. Select "Metallic"
when using Gold or Silver.
• Increasing the frequency of cleaning will shorten the replacement cycle of the fuser cleaning unit.
• After performing the solution, it is recommended to perform the color calibration of the external
printer controller.
White Spots, Colored Streaks
White spots and colored streaks appear on solid-fill images.
Cause:
Toner becomes coagulated in the toner supply path. White spots occur due to the coagulated toner and
because the toner around it fails to be transferred. Colored streaks occur due to the coagulated toner
melting in the development unit.
6. Image Quality Problem: Spots
186
To Next Page
Loading...
