Insufficient Fusibility
Insufficient Fusibility
Cause:
• The paper type, paper thickness, or coating type is not specified correctly in the paper settings.
• The type or thickness of the paper being used differs from that of the paper specified in the settings.
• Paper of a different lot is being used.
Solution:
1. If the paper is not registered as custom paper, register the brand of the paper.
2. In [Detailed settings] for custom paper, select 1232: [Fusing Temperature] and increase
the temperature setting for the fusing heat roller by 5°C according to the color mode you
wish to use.
• 1232-01: Fusing Temperature: BW/FC/FCS: Heat Roller Temp
• 1232-06: Fusing Temperature: FCS: Heat Roller Temp: Clear/Special
• 1232-07: Fusing Temperature: FCS: Heat Roller Temp: White
• 1232-08: Fusing Temperature: FCS: Heat Roller Temp: Metallic
• 1232-26: Fusing Temperature: S: Heat Roller Temp: Clear/Special
• 1232-27: Fusing Temperature: S: Heat Roller Temp: White
• 1232-28: Fusing Temperature: S: Heat Roller Temp: Metallic
• 1232-46: Fusing Temperature: BW/FC/FCS: Fuser Setting HQ: Heat Roller Temp
• 1232-51: Fusing Temperature: FCS: Fuser Setting HQ: Heat Roller Temp: Clear/Special
• 1232-52: Fusing Temperature: FCS: Fuser Setting HQ: Heat Roller Temp: White
• 1232-53: Fusing Temperature: FCS: Fuser Setting HQ: Heat Roller Temp: Metallic
• 1232-71: Fusing Temperature: S: Fuser Setting HQ: Heat Roller Temp: Clear/Special
• 1232-72: Fusing Temperature: S: Fuser Setting HQ: Heat Roller Temp: White
• 1232-73: Fusing Temperature: S: Fuser Setting HQ: Heat Roller Temp: Metallic
3. Print and check if the fusibility is within the acceptable range. (3 or more sheets of A3
paper)
• The required level of fusibility is as follows.
Insufficient Fusibility
321
To Next Page
Loading...
