Ricoh Pro C7500 - Page 324

• The printed image does not come off.
• The toner does not come off even if it is lightly rubbed by a nail.
• The toner does not come off even if the image is wiped with an optical cloth.
Yes Finished!
No If the fusing heat roller temperature has not yet reached 185°C, start over from
Step 2.
If the problem persists even after reaching 185°C, go to the next step.
4. In [Detailed settings] for custom paper, select 1231: [Motor Speed], and then change the
print speed from [High] to [Middle].
If it is already set to [Middle] or [Low], go to Step 6.
• 1231-01: Print Speed: BW/FC/FCS: BW/FC/FCS
• 1231-02: Print Speed: FCS: Clear/Special
• 1231-03: Print Speed: FCS: White
• 1231-04: Print Speed: FCS: Metallic
• 1231-06: Print Speed: S: Clear/Special
• 1231-07: Print Speed: S: White
• 1231-08: Print Speed: S: Metallic
• 1231-10: Print Speed: BW/FC/FCS: Fuser Setting HQ: BW/FC/FCS
• 1231-11: Print Speed: FCS: Fuser Setting HQ: Clear/Special
• 1231-12: Print Speed: FCS: Fuser Setting HQ: White
• 1231-13: Print Speed: FCS: Fuser Setting HQ: Metallic
• 1231-15: Print Speed: S: Fuser Setting HQ: Clear/Special
• 1231-16: Print Speed: S: Fuser Setting HQ: White
• 1231-17: Print Speed: S: Fuser Setting HQ: Metallic
5. Print and check if the issue is within the acceptable range. (Print 10 or more A3 sheets.)
Yes Finished!
No Go to the next step.
6. Change the print speed to "Low".
7. Print and check if the issue is within the acceptable range. (Print 3 or more A3 sheets.)
Yes Finished!
No Go to the next step.
12. Problems Related to Throughput
322