8. Go back to 1232: [Fusing Temperature] and increase the fusing heat roller's temperature
by 5°C.
9. Print and check if the issue is within the acceptable range. (Print 3 or more A3 sheets.)
Yes Finished!
No Start over from Step 8 until the fusing heat roller temperature reaches 200°C.
If the problem persists even after reaching 200°C, there is no other solution.
• Select "Clear/Special" when using Neon Yellow, Neon Pink, or Invisible Red. Select "Metallic"
when using Gold or Silver.
• The first printout after changing the temperature setting may take a while to start printing
• After performing the solution, it is recommended to perform the color calibration of the external
printer controller.
Insufficient Fusibility
323
To Next Page
Loading...
