6. In [Detailed settings] for custom paper, select 1321: [Correct Paper Curl], and then
specify [Correction Mode].
To correct curls facing up, specify "U Curl Correction Level: Large" or "U Curl Correction Level:
Small".
To correct curls facing down, specify "П Curl Correction Level: Large" or "П Curl Correction Level:
Small".
7. Print the image. Has the problem been resolved?
Yes Finished!
No Repeat Steps 6 and 7.
If the problem persists, there is no other solution.
• Select "Clear/Special" when using Neon Yellow, Neon Pink, or Invisible Red. Select "Metallic"
when using Gold or Silver.
White Spots or Scratches due to Paper Dust
Cause:
White spots or scratches occur due to paper dust.
Depending on the amount of paper dust and the type of paper, scratches may occur.
Solution:
Clean the main unit's paper dust case, transfer timing roller, and the transport guide plates for the paper
path from paper feeding up to paper delivery.
This problem can be resolved by cleaning the paper feed guides from the paper feed tray, where the
paper affected with white spots or scratches is loaded, up to the paper delivery route, including the exit
switchback unit and duplex printing paper path.
See page 203 "Cleaning the Machine's Trays 1 and 2"
See page 205 "Cleaning the Paper Feeding Section of the Bypass Tray"
See page 210 "Cleaning the Machine's Transfer Unit"
See page 281 "Cleaning the Vacuum Feed LCIT RT5150"
See page 283 "Cleaning the Wide LCT Connection Unit"
Streaks, Scratches, Disturbed Image, Crease
241
To Next Page
Loading...
