3. Print 20 or more A4 sheets. Has the problem been resolved?
Yes Finished!
No Start over from Step 2.
If the problem persists even when the fusing heat roller's temperature is increased
the upper limit, contact your service representative.
• The upper limit for the fusing heat roller's temperature depends on the print speed
• At normal/constant speed, the upper limit is 185°C
• At low speed, the upper limit is 200°C.
• Select "Clear/Special" when using Neon Yellow, Neon Pink, or Invisible Red. Select "Metallic"
when using Gold or Silver.
• After performing the solution, it is recommended to perform the color calibration of the external
printer controller.
Vertical Glossy (In-track) Streaks (Due to the Toner Wax on the Image)
Toner wax in the shape of the fuser belt smoothing roller stains the image.
Cause:
This is caused by uneven wax adhesion on the fusing belt.
This is prone to occur when printing images covering a high image area of 40% or more in total of all
colors on paper with a thickness of Paper Weight 4 or more.
Streaks
179
To Next Page
Loading...
