Cause:
A trace of abrasive streaks produced by the fusing belt smoothing operation remains on the fusing belt.
This is prone to occur when using paper with a thickness of Paper Weight 7, 8 or 9.
Solution:
1. If the paper is not registered as custom paper, register the brand of the paper.
2. In [Detailed settings] for custom paper, select 1232: [Fusing Temperature] and increase
the temperature setting for the fusing heat roller by 5°C according to the color mode you
wish to use.
• 1232-01: Fusing Temperature: BW/FC/FCS: Heat Roller Temp
• 1232-06: Fusing Temperature: FCS: Heat Roller Temp: Clear/Special
• 1232-07: Fusing Temperature: FCS: Heat Roller Temp: White
• 1232-08: Fusing Temperature: FCS: Heat Roller Temp: Metallic
• 1232-26: Fusing Temperature: S: Heat Roller Temp: Clear/Special
• 1232-27: Fusing Temperature: S: Heat Roller Temp: White
• 1232-28: Fusing Temperature: S: Heat Roller Temp: Metallic
• 1232-46: Fusing Temperature: BW/FC/FCS: Fuser Setting HQ: Heat Roller Temp
• 1232-51: Fusing Temperature: FCS: Fuser Setting HQ: Heat Roller Temp: Clear/Special
• 1232-52: Fusing Temperature: FCS: Fuser Setting HQ: Heat Roller Temp: White
• 1232-53: Fusing Temperature: FCS: Fuser Setting HQ: Heat Roller Temp: Metallic
• 1232-71: Fusing Temperature: S: Fuser Setting HQ: Heat Roller Temp: Clear/Special
• 1232-72: Fusing Temperature: S: Fuser Setting HQ: Heat Roller Temp: White
• 1232-73: Fusing Temperature: S: Fuser Setting HQ: Heat Roller Temp: Metallic
5. Image Quality Problem: Lines/Streaks
178
To Next Page
Loading...
