• 1232-52: Fusing Temperature: FCS: Fuser Setting HQ: Heat Roller Temp: White
• 1232-53: Fusing Temperature: FCS: Fuser Setting HQ: Heat Roller Temp: Metallic
• 1232-71: Fusing Temperature: S: Fuser Setting HQ: Heat Roller Temp: Clear/Special
• 1232-72: Fusing Temperature: S: Fuser Setting HQ: Heat Roller Temp: White
• 1232-73: Fusing Temperature: S: Fuser Setting HQ: Heat Roller Temp: Metallic
3. Print and check if the stain on the edge of the paper is within the acceptable range. (Print
10 or more sheets.)
Yes Finished!
No Start over from Step 2.
If the problem persists even after increasing the fusing heat roller temperature to
185°C, go to the next step.
4. Select 1231: [Print Speed], and then check the present value in the following
corresponding settings.
• 1231-01: Print Speed: BW/FC/FCS: BW/FC/FCS
• 1231-02: Print Speed: FCS: Clear/Special
• 1231-03: Print Speed: FCS: White
• 1231-04: Print Speed: FCS: Metallic
• 1231-06: Print Speed: S: Clear/Special
• 1231-07: Print Speed: S: White
• 1231-08: Print Speed: S: Metallic
• 1231-10: Print Speed: BW/FC/FCS: Fuser Setting HQ: BW/FC/FCS
• 1231-11: Print Speed: FCS: Fuser Setting HQ: Clear/Special
• 1231-12: Print Speed: FCS: Fuser Setting HQ: White
• 1231-13: Print Speed: FCS: Fuser Setting HQ: Metallic
• 1231-15: Print Speed: S: Fuser Setting HQ: Clear/Special
• 1231-16: Print Speed: S: Fuser Setting HQ: White
• 1231-17: Print Speed: S: Fuser Setting HQ: Metallic
[Middle] or [Low] Proceed to Step 7.
[High] Go to the next step.
5. Change the print speed to "Middle".
4. Image Quality Problem: Full Page
54
To Next Page
Loading...
