Solution:
(a) Adjusting the image density
1. Enable image processing.
1. Launch Fiery Command WorkStation.
2. Click the job properties for the print image.
3. Click the color tab.
4. Click the color input.
5. Check the CMYK source setting. If it is set to "ColorWise OFF", change it to another setting.
2. When printing images with high toner adhesion and density, enable Toner Reduction.
1. Launch Fiery Command WorkStation.
2. Click the job properties for the print image.
3. Click the image tab.
4. Select Toner Reduction.
3. Print the image. Has the problem been resolved?
Yes Finished!
No Go to the next step.
4. In the [Machine: Image Quality] group on the [Operator Adjust.] menu, select 0201:
[Execute Image Quality Adjustment] and execute [Adjust Image Density].
5. Adjust the amount of toner adhesion.
1. In Adjustment Settings for Operators, select 0202-01 to -05 [Maximum Image Density] and
change the amount of toner adhesion.
2. In the case of [Detailed settings] for custom paper, decrease the image density in the
following settings.
• 1201-01: Maximum Image Density: Black
• 1201-02: Maximum Image Density: Cyan
• 1201-03: Maximum Image Density: Magenta
• 1201-04: Maximum Image Density: Yellow
• 1201-05: Maximum Image Density: Clear/Special
• 1201-06: Maximum Image Density: White
• 1201-07: Maximum Image Density: Metallic
4. Image Quality Problem: Full Page
128
To Next Page
Loading...
