3. Is the paper curled?
4. Check if the curl is within the acceptable range.
Yes Finished!
No Go to the next step.
5. In [Detailed settings] for custom paper, select 1321: [Correct Paper Curl], and then
execute decurling.
To correct curls facing up, specify "U Curl Correction Level: Large" or "U Curl Correction Level:
Small".
To correct curls facing down, specify "П Curl Correction Level: Large" or "П Curl Correction Level:
Small".
6. Print the image. Has the problem been resolved?
Yes Finished!
No Repeat Steps 5 and 6.
If the problem persists, there is no other solution.
7. Check for glossiness problems.
Yes Start over from Step 2.
No Finished!
8. Check to see if the fluctuation of the tone of images covering high image areas (solid-fill
images) is within the acceptable range.
9. Launch Fiery Command WorkStation.
10. Click the job properties for the print image.
11. Click the image tab.
12. Turn on Toner Reduction.
13. Print the image and check if there are any problems with fusibility.
Yes Restore the value in 1232: [Fusing Temperature] to its previous setting. (+5°C)
No further improvement is likely.
No Go to the next step.
14. Check for glossiness problems.
Yes No further improvement is likely.
4. Image Quality Problem: Full Page
134
To Next Page
Loading...
