No Proceed to Step 7.
5. Switch the positions of K and S toners. (back to their normal positions)
6. Print the image. Has the problem been resolved?
Yes Finished!
No Go to the next step.
7. If the paper is not registered as custom paper, register the brand of the paper.
8. In [Detailed settings] for custom paper, select 1237: [Print Speed (Sheet Interval Adj)],
and then decrease the values of the following items according to the mode you use.
• 1237-01: Print Speed (Sheet Interval Adj): BW/FC/FCS: BW/FC/FCS
• 1237-02: Print Speed (Sheet Interval Adj): FCS: Clear/Special
• 1237-03: Print Speed (Sheet Interval Adj): FCS: White
• 1237-04: Print Speed (Sheet Interval Adj): FCS: Metallic
• Increase the intervals between the transported sheets so as to move the areas affected by the
shock jitter out of the print area or between the sheets.
• If the problem is caused by the intermediate transfer belt vibration made when the paper
enters the paper transfer nip, you can move the areas affected by the shock jitter
approximately 5 mm toward the leading edge of the paper by decreasing the value by 1 %.
• If the problem is caused by the intermediate transfer belt vibration made when the paper exits
from the paper transfer nip, you can move the areas affected by the shock jitter approximately
10 mm toward the leading edge of the paper by decreasing the value by 1 %.
• Depending on the value, throughput may be reduced.
9. Print the image. Has the problem been resolved?
Yes Finished!
No Go to the next step.
10. In [Detailed settings] for the custom paper you are using, select 1212: [Image Transfer
Output], increase the value by one step.
• 1212-02: Image Transfer Output: FC/FCS: Black
• 1212-03: Image Transfer Output: FC/FCS: Cyan
• 1212-04: Image Transfer Output: FC/FCS: Magenta
• 1212-05: Image Transfer Output: FC/FCS: Yellow
• 1212-06: Image Transfer Output: FC/FCS: Clear/Special
Bands
161
To Next Page
Loading...
