Procedure 2: Changing the print speed
This will slow down the printing to give the toner more time to fuse. However, because of this,
throughput will be reduced.
1. In [Detailed settings] for the custom paper you are using, select 1231: [Print Speed],
and then decrease the value in the following corresponding settings by one step.
If the present value is [High], select [Middle]. If it is [Middle], select [Low].
2. Is 1231: [Print Speed] set to [Low]?
Yes Go to the next step.
No Proceed to Step 4.
3. In [Detailed settings] for the custom paper you are using, select 1232: [Fusing
Temperature], and then set the value in the following corresponding settings by 10.
4. Print the image and check toner fusion. Has the problem been resolved?
Yes Finished!
No Go to the next step.
5. Is 1231: [Print Speed] set to [Middle]?
6. In [Detailed settings] for the custom paper you are using, select 1232: [Fusing
Temperature], and then set the value in the following corresponding settings by 10.
7. Print the image and check toner fusion. Has the problem been resolved?
Yes Finished!
No Increase the temperature further by 5°C.
If the problem persists even after increasing the value to "200", contact your
service representative.
• If you change the value of 1231: [Print Speed] from [Low] to [High] or to [Middle], in 1232:
[Fusing Temperature], reset the value of [Correct Temp: Pre-Feed] to its default value.
• Changing the fusing temperature or changing the process speed may produce one or more of the
following side effects:
• Paper curling
• Paper misfeeding
• Blisters
• Glossy lines
• Change of gloss
Adjusting Paper Settings
17
To Next Page
Loading...
