Ricoh Pro C7500 - Page 197

• 1232-34: Fusing Temperature: S: Correct Temp: Pre-Feed: Clear/Special
• 1232-35: Fusing Temperature: S: Correct Temp: Pre-Feed: White
• 1232-36: Fusing Temperature: S: Correct Temp: Pre-Feed: Metallic
High Quality
• 1232-48: Fusing Temperature: BW/FC/FCS: Fuser Setting HQ: Correct Temp: Pre-Feed
• 1232-59: Fusing Temperature: FCS: Fuser Setting HQ: Correct Temp: Pre-Feed: Clear/
Special
• 1232-60: Fusing Temperature: FCS: Fuser Setting HQ: Correct Temp: Pre-Feed: White
• 1232-61: Fusing Temperature: FCS: Fuser Setting HQ: Correct Temp: Pre-Feed: Metallic
• 1232-79: Fusing Temperature: S: Fuser Setting HQ: Correct Temp: Pre-Feed: Clear/Special
• 1232-80: Fusing Temperature: S: Fuser Setting HQ: Correct Temp: Pre-Feed: White
• 1232-81: Fusing Temperature: S: Fuser Setting HQ: Correct Temp: Pre-Feed: Metallic
4. Print 10 or more A3 sheets. Has the problem been resolved?
Yes Proceed to Step 7.
No Go to the next step.
5. Go back to 1232: [Fusing Temperature] and decrease the fusing heat roller's temperature
by 5°C.
6. Print 10 or more A3 sheets. Has the problem been resolved?
Yes Proceed to Step 7.
No Start over from Step 5.
7. Check to see if the fusibility is within the acceptable range.
• The required level of fusibility is as follows.
• The printed image does not come off.
• The toner does not come off even if it is lightly rubbed by a nail.
• The toner does not come off even if it is rubbed by the cloth for cleaning the contact
glass.
Yes Finished!
No No further improvement is likely.
Spots
195