• Since wax adheres to the machine's cooling belt, it is recommended to clean it with alcohol every
100K sheets of printing.
• If toner stains or paper dust are found on the surrounding guide plates, clean the guide plates too.
1. Remove the Fuser Unit.
2. Using an alcohol-dampened cloth, wipe the cooling belt [A] back and forth 3 times in the
direction of the belt width.
Be sure to wipe the part completely.
3. Rotate the drive roller [A] approximately 30°, and then wipe the cooling belt [B].
Cleaning the Parts of the Machine
219
To Next Page
Loading...
