• 1232-77: Fusing Temperature: S: Fuser Setting HQ: Correct Temp: Initial Feed: Metallic
8. Select 1232: [Correct Temp: Initial Feed], and then set the temperature adjustment before
paper feeding to "5°C" according to the color mode you wish to use.
• 1232-03: Fusing Temperature: BW/FC/FCS: Correct Temp: Pre-Feed
• 1232-14: Fusing Temperature: FCS: Correct Temp: Pre-Feed: Clear/Special
• 1232-15: Fusing Temperature: FCS: Correct Temp: Pre-Feed: White
• 1232-16: Fusing Temperature: FCS: Correct Temp: Pre-Feed: Metallic
• 1232-34: Fusing Temperature: S: Correct Temp: Pre-Feed: Clear/Special
• 1232-35: Fusing Temperature: S: Correct Temp: Pre-Feed: White
• 1232-36: Fusing Temperature: S: Correct Temp: Pre-Feed: Metallic
• 1232-48: Fusing Temperature: BW/FC/FCS: Fuser Setting HQ: Correct Temp: Pre-Feed
• 1232-59: Fusing Temperature: FCS: Fuser Setting HQ: Correct Temp: Pre-Feed: Clear/
Special
• 1232-60: Fusing Temperature: FCS: Fuser Setting HQ: Correct Temp: Pre-Feed: White
• 1232-61: Fusing Temperature: FCS: Fuser Setting HQ: Correct Temp: Pre-Feed: Metallic
• 1232-79: Fusing Temperature: S: Fuser Setting HQ: Correct Temp: Pre-Feed: Clear/Special
• 1232-80: Fusing Temperature: S: Fuser Setting HQ: Correct Temp: Pre-Feed: White
• 1232-81: Fusing Temperature: S: Fuser Setting HQ: Correct Temp: Pre-Feed: Metallic
9. Print the image. Has the problem been resolved? (10 or more sheets of A4 paper)
Yes Go to the next step.
No Proceed to "Decrease the fusing heating roller temperature"
10. Check to see if the fusibility is within the acceptable range.
• The required level of fusibility is as follows.
• The printed image does not come off.
• The toner does not come off even if it is lightly rubbed by a nail.
• The toner does not come off even if the image is wiped with an optical cloth.
Yes Finished!
No No further improvement is likely.
8. Troubles Related to Paper Feeding and Delivery (Main)
250
To Next Page
Loading...
