Solution:
1. Perform the common troubleshooting procedure.
For details, see page 267 "Common Troubleshooting".
2. Check if the double feeding is resolved.
Yes Finished!
No Go to the next step.
3. If using paper with a thickness of Paper Weight 5 or below, extend the paper retainer.
If using paper with a thickness of Paper Weight 6 or above, go to the next step.
4. To feed paper from LCT banner sheet tray, attach the end fence for long paper.
For details, see page 279 "Attaching the Side Fences, Auxiliary Side Fence, and End Fence (for
Long Paper)".
• For paper with a length of 420.0 mm to 559.9 mm (16.5 inches to 22.0 inches), attach the 2
short end fences.
• For paper with a length of 560.0 mm to 700.0 mm (22.0 inches to 27.6 inches), attach the 1
long end fence.
If Vacuum Feed Banner Sheet Tray Type S9 is not used, go to the next step.
5. To print on tab stocks, attach the tab sheet holder.
For details, see page 279 "Attaching the Tab Fence in the Wide Large Capacity Tray".
To print on other types of paper, go to the next step.
6. Check if the double feeding is resolved.
Yes Finished!
No Go to the next step.
10. Troubles Related to Paper Feeding and Delivery (Vacuum Feed LCIT RT5150)
268
To Next Page
Loading...
