3. Is the finisher shift tray selected to the output tray?
Yes Proceed to Step 6.
No Go to the next step.
4. Select the finisher shift tray to the output tray.
5. Print the image. Has the problem been resolved?
Yes Finished!
No Go to the next step.
6. In [Detailed settings] for the custom paper you are using, select 1232: [Fusing
Temperature], select [Heat Roller Temp], and then decrease the value in the following
corresponding settings by 5°C.
• 1232-01: Fusing Temperature: BW/FC/FCS: Heat Roller Temp
• 1232-06: Fusing Temperature: FCS: Heat Roller Temp: Clear/Special
• 1232-07: Fusing Temperature: FCS: Heat Roller Temp: White
• 1232-08: Fusing Temperature: FCS: Heat Roller Temp: Metallic
• 1232-26: Fusing Temperature: S: Heat Roller Temp: Clear/Special
• 1232-27: Fusing Temperature: S: Heat Roller Temp: White
• 1232-28: Fusing Temperature: S: Heat Roller Temp: Metallic
• 1232-46: Fusing Temperature: BW/FC/FCS: Fuser Setting HQ: Heat Roller Temp
• 1232-51: Fusing Temperature: FCS: Fuser Setting HQ: Heat Roller Temp: Clear/Special
• 1232-52: Fusing Temperature: FCS: Fuser Setting HQ: Heat Roller Temp: White
• 1232-53: Fusing Temperature: FCS: Fuser Setting HQ: Heat Roller Temp: Metallic
• 1232-71: Fusing Temperature: S: Fuser Setting HQ: Heat Roller Temp: Clear/Special
• 1232-72: Fusing Temperature: S: Fuser Setting HQ: Heat Roller Temp: White
• 1232-73: Fusing Temperature: S: Fuser Setting HQ: Heat Roller Temp: Metallic
7. Print 20 or more sheets. Is the condition of the image acceptable?
Yes Go to the next step.
No No further improvement is likely.
8. Check if the toner fusibility is within the permissible range.
• The required level of fusibility is as follows.
Other Post- Processing Options
315
To Next Page
Loading...
