Solution:
• You need to register the paper as custom paper in advance.
1. Load the sheets the other way up.
2. Print the image. Has the problem been resolved?
Yes Finished!
No Go to the next step.
3. In the printer settings, change the paper to be output in faced up.
4. Print the image. Has the problem been resolved?
Yes Finished!
No Go to the next step.
5. Check if the settings are specified to deliver paper to the finisher shift tray.
Yes Proceed to Step 8.
No Go to the next step.
6. Select the finisher shift tray to the output tray.
7. Print the image. Has the problem been resolved?
Yes Finished!
No Go to the next step.
8. In [Detailed settings] for the custom paper you are using, select 1232: [Fusing
Temperature], select [Heat Roller Temp], and then decrease the value in the following
corresponding settings by 5°C.
• 1232-01: Fusing Temperature: BW/FC/FCS: Heat Roller Temp
• 1232-06: Fusing Temperature: FCS: Heat Roller Temp: Clear/Special
• 1232-07: Fusing Temperature: FCS: Heat Roller Temp: White
• 1232-08: Fusing Temperature: FCS: Heat Roller Temp: Metallic
• 1232-26: Fusing Temperature: S: Heat Roller Temp: Clear/Special
• 1232-27: Fusing Temperature: S: Heat Roller Temp: White
• 1232-28: Fusing Temperature: S: Heat Roller Temp: Metallic
• 1232-46: Fusing Temperature: BW/FC/FCS: Fuser Setting HQ: Heat Roller Temp
Other Post- Processing Options
317
To Next Page
Loading...
