2. In [Detailed settings] for custom paper, Select 1212: [Image Transfer Output], and then
check if the value for the intermediate (image) transfer output for the mode you use is set
to "+10" (upper limit).
• 1212-01: Image Transfer Output: BW: Black
• 1212-02: Image Transfer Output: FC/FCS: Black
• 1212-03: Image Transfer Output: FC/FCS: Cyan
• 1212-04: Image Transfer Output: FC/FCS: Magenta
• 1212-05: Image Transfer Output: FC/FCS: Yellow
• 1212-06: Image Transfer Output: FC/FCS: Clear/Special
• 1212-07: Image Transfer Output: FC/FCS: White
• 1212-08: Image Transfer Output: FC/FCS: Metallic
• 1212-10: Image Transfer Output: S: Clear/Special
• 1212-11: Image Transfer Output: S: White
• 1212-12: Image Transfer Output: S: Metallic
Yes If already set to the upper limit, there is no other solution.
No Go to the next step.
3. Increase the value by one step.
4. Print the image. Has the problem been resolved?
Yes Finished!
No Start over from Step 3.
(b) Adjusting the printing speed
1. In [Detailed settings] for the custom paper you are using, select 1231: [Print Speed], and
then set the value in the following corresponding settings to [Low].
Productivity Priority
• 1231-01: Print Speed: BW/FC/FCS: BW/FC/FCS
• 1231-02: Print Speed: FCS: Clear/Special
• 1231-03: Print Speed: FCS: White
• 1231-04: Print Speed: FCS: Metallic
• 1231-06: Print Speed: S: Clear/Special
• 1231-07: Print Speed: S: White
• 1231-08: Print Speed: S: Metallic
4. Image Quality Problem: Full Page
44
To Next Page
Loading...
