• 1232-61: Fusing Temperature: FCS: Fuser Setting HQ: Correct Temp: Pre-Feed: Metallic
• 1232-79: Fusing Temperature: S: Fuser Setting HQ: Correct Temp: Pre-Feed: Clear/Special
• 1232-80: Fusing Temperature: S: Fuser Setting HQ: Correct Temp: Pre-Feed: White
• 1232-81: Fusing Temperature: S: Fuser Setting HQ: Correct Temp: Pre-Feed: Metallic
8. Print the image. Has the problem been resolved? (10 or more sheets of A4 paper)
Yes Go to the next step.
No Proceed to "Decreasing the Fusing Heat Roller Temperature".
9. Check to see if the fusibility is within the acceptable range.
• The required level of fusibility is as follows.
• The printed image does not come off.
• The toner does not come off even if it is lightly rubbed by a nail.
• The toner does not come off even if the image is wiped with an optical cloth.
Yes Finished!
No No further improvement is likely.
Decreasing the Fusing Heat Roller Temperature
1. In [Detailed settings] for custom paper, select 1232: [Fusing Temperature] and decrease
the temperature setting for the fusing heat roller by 5°C according to the color mode you
wish to use.
2. Print the image. Has the problem been resolved? (10 or more sheets of A4 paper)
Yes Go to the next step.
No Start over from Step 1.
3. Check to see if the fusibility is within the acceptable range.
• The required level of fusibility is as follows.
• The printed image does not come off.
• The toner does not come off even if it is lightly rubbed by a nail.
• The toner does not come off even if the image is wiped with an optical cloth.
Yes Finished!
Dirtied Printouts
49
To Next Page
Loading...
