Solution:
(a) Execute Toner Refreshing.
1. Print 30 sheets of solid-fill images with 100% density for each color of CMYK.
• The page yield decreases as a side effect.
(b) Adjust the image transfer output.
1. If the paper is not registered as custom paper, register the brand of the paper.
2. In [Detailed settings] for the custom paper you are using, select 1212: [Image Transfer
Output], and then decrease the value by 5.
• 1212-02: Image Transfer Output: FC/FCS: Black
• 1212-03: Image Transfer Output: FC/FCS: Cyan
• 1212-04: Image Transfer Output: FC/FCS: Magenta
• 1212-05: Image Transfer Output: FC/FCS: Yellow
• Decreasing the image transfer output may cause a faint image. If the image is too faint, adjust
the value between "-5" and "-3".
If the problem persists after executing Toner Refreshing and image transfer output adjustment, go to
the (d) procedure for changing the AC transfer mode setting.
(c) Change the paper brand
1. Assign the textured paper with the closest paper thickness from the media library.
(d) changing the AC transfer mode setting.
1. In [Detailed settings] for the custom paper you are using, set 1218-01: [Paper Transfer
Output] to [Textured Paper].
2. In accordance with the problem, perform the solution as follows.
Transfer error on indentations of the paper
1. Change the paper transfer voltage to "+2"
• 1214-07: Paper Transfer Output: FC/FCS: Side 1: AC
• 1214-08: Paper Transfer Output: FC/FCS: Side 2: AC
2. Print the image. Has the problem been resolved?
Yes Finished!
Uneven Density
65
To Next Page
Loading...
