• 1232-55: Fusing Temperature: FCS: Fuser Setting HQ: Correct Temp: Initial Feed: Clear/
Special
• 1232-56: Fusing Temperature: FCS: Fuser Setting HQ: Correct Temp: Initial Feed: White
• 1232-57: Fusing Temperature: FCS: Fuser Setting HQ: Correct Temp: Initial Feed: Metallic
• 1232-75: Fusing Temperature: S: Fuser Setting HQ: Correct Temp: Initial Feed: Clear/Special
• 1232-76: Fusing Temperature: S: Fuser Setting HQ: Correct Temp: Initial Feed: White
• 1232-77: Fusing Temperature: S: Fuser Setting HQ: Correct Temp: Initial Feed: Metallic
3. Set the value in the following corresponding settings to 5°C.
Productivity Priority
• 1232-03: Fusing Temperature: BW/FC/FCS: Correct Temp: Pre-Feed
• 1232-14: Fusing Temperature: FCS: Correct Temp: Pre-Feed: Clear/Special
• 1232-15: Fusing Temperature: FCS: Correct Temp: Pre-Feed: White
• 1232-16: Fusing Temperature: FCS: Correct Temp: Pre-Feed: Metallic
• 1232-34: Fusing Temperature: S: Correct Temp: Pre-Feed: Clear/Special
• 1232-35: Fusing Temperature: S: Correct Temp: Pre-Feed: White
• 1232-36: Fusing Temperature: S: Correct Temp: Pre-Feed: Metallic
High Quality
• 1232-48: Fusing Temperature: BW/FC/FCS: Fuser Setting HQ: Correct Temp: Pre-Feed
• 1232-59: Fusing Temperature: FCS: Fuser Setting HQ: Correct Temp: Pre-Feed: Clear/
Special
• 1232-60: Fusing Temperature: FCS: Fuser Setting HQ: Correct Temp: Pre-Feed: White
• 1232-61: Fusing Temperature: FCS: Fuser Setting HQ: Correct Temp: Pre-Feed: Metallic
• 1232-79: Fusing Temperature: S: Fuser Setting HQ: Correct Temp: Pre-Feed: Clear/Special
• 1232-80: Fusing Temperature: S: Fuser Setting HQ: Correct Temp: Pre-Feed: White
• 1232-81: Fusing Temperature: S: Fuser Setting HQ: Correct Temp: Pre-Feed: Metallic
4. Print 10 or more A3 sheets. Has the problem been resolved?
Yes Proceed to Step 7.
No Go to the next step.
5. Go back to 1232: [Fusing Temperature] and decrease the fusing heat roller's temperature
by 5°C.
6. Print 10 or more A3 sheets. Has the problem been resolved?
Yes Go to the next step.
4. Image Quality Problem: Full Page
70
To Next Page
Loading...
