If you select [Level 2], specify the password using a combination of three types of characters
selected from upper-case letters, lower-case letters, decimal numbers, and symbols such as #.
Default: [Off], Minimum required number of characters not specified
@Remote Service
This can be specified by the machine administrator.
Communication via HTTPS for @Remote Service is disabled if you select [Prohibit].
When setting it to [Prohibit], consult with your service representative.
If it is set to [Proh. Some Services], it becomes impossible to change settings via a remote
connection, providing optimally secure operation.
Default: [Do not Prohibit]
Update Firmware
This can be specified by the machine administrator.
Specify whether to allow firmware updates on the printer. Firmware update means having the
service representative update the firmware or updating the firmware via the network.
If you select [Prohibit], firmware on the printer cannot be updated.
If you select [Do not Prohibit], there are no restrictions on firmware updates.
Default: [Do not Prohibit]
Change Firmware Structure
This can be specified by the machine administrator.
Specify whether to prevent changes in the printer's firmware structure. The Change Firmware
Structure function detects when the SD card is inserted, removed or replaced.
If you select [Prohibit], the printer stops during startup when a firmware structure change is detected
and a message requesting administrator login is displayed. After the machine administrator logs in,
the printer finishes startup with the updated firmware.
The administrator can confirm if the updated structure change is permissible or not by checking the
firmware version displayed on the control panel screen. If the firmware structure change is not
permissible, contact your service representative before logging in.
When "Change Firmware Structure" is set to [Prohibit], administrator authentication must be
enabled.
After [Prohibit] is specified, disable administrator authentication. When administrator authentication
is enabled again, you can return the setting to [Do not Prohibit].
If you select [Do not Prohibit], firmware structure change detection is disabled.
Default: [Do not Prohibit]
Password Entry Violation
This can be specified by the machine administrator.
7. Managing the Printer
222
To Next Page
Loading...
Need help?
General
Weight and Dimensions
