Rigol DS2000E Series

2 Command System RIGOL
DS2000E Programming Guide
2-97
:DISPlay Commands
 :DISPlay:CLEar
 :DISPlay:TYPE
 :DISPlay:GRADing:TIME
 :DISPlay:WBRightness
 :DISPlay:GRID
 :DISPlay:GBRightness
 :DISPlay:MPERsistence
 :DISPlay:DATA?
:DISPlay:CLEar
Syntax
:DISPlay:CLEar
Description
Clear all the waveforms on the screen. The function of this command is the same with that of CLEAR on
the front panel.
Explanation
 If the oscilloscope is in RUN state (refer to the :RUN command), new waveforms will still be
displayed.
 You can also use the
:CLEar command to clear all the waveforms on the screen.