Rigol DS2000E Series

2 Command System RIGOL
DS2000E Programming Guide
2-19
:BUS<n>:PARallel
 :BUS<n>:PARallel:CLK
 :BUS<n>:PARallel:SLOPe
 :BUS<n>:PARallel:BSET
 :BUS<n>:PARallel:THReshold
 :BUS<n>:PARallel:OFFSet
:BUS<n>:PARallel:CLK
Syntax
:BUS<n>:PARallel:CLK <sour>
:BUS<n>:PARallel:CLK?
Description
Set or query the clock channel source of parallel decoding on the specified bus.
Parameter
Name Type Range Default
<n> Discrete {1|2} --
<sour> Discrete {CHANnel1|CHANnel2|OFF} CHANnel1
Explanation
When OFF is selected, no clock channel is set and the oscilloscope samples data once the channel data
jumps. At this point, the edge set by the
:BUS<n>:PARallel:SLOPe command can be ignored.
Return Format
The query returns CHAN1, CHAN2, or OFF.
:BUS<n>:PARallel:SLOPe
Syntax
:BUS<n>:PARallel:SLOPe <pos>
:BUS<n>:PARallel:SLOPe?
Description
Set or query the edge of the clock on which the oscilloscope samples the channel data.
Parameter
Name Type Range Default
<n> Discrete {1|2} --
<pos> Discrete {POSitive|NEGative|BOTH} POSitive