Riso 9150 - Page 118

2-40
2 Copy
ComColor Series User’s Guide 09
● Retrieving a Program
Retrieve a saved program.
1 Display the [Program (1)] screen.
Follow Steps 1 and 2 in "Configuring the
Program".
2 Press [Save/Call].
The [Program list] screen is displayed.
3 Select the program to retrieve.
Select one program.
4 Press [Retrieve].
The [Program (1)] screen for the selected settings
is displayed.
5 Press [Next].
The [Program (2)] screen is displayed.
6 Configure the [Collate], [Slip sheet],
and [Offset output] settings.
You cannot use this function with "Collate/slip
sheet" on the [Functions] screen.
7 Press [OK].
The settings are confirmed and the copy mode
screen is displayed.
• To return to the [Program (1)] screen, press
[Back].
● Renaming a Program
1 Display the [Program (1)] screen.
Follow Steps 1 and 2 in "Configuring the
Program".
2 Press [Save/Call].
The [Program list] screen is displayed.
3 Select the program to rename.
Select one program.
4 Press [Rename].
The [Rename] screen is displayed.
The current registration name is displayed in the
input box.
5 Enter the new registration name.
• Enter a name up to 10 characters long on the
text input screen. (p. 19 "Entering Text")
6 Press [OK].
The new registration name is saved and the
[Program list] screen is displayed.
• To only rename the program, press [Close],
and then press [Cancel] on the [Program (1)]
screen.
• To copy, press [Close] and then press [Next] on
the [Program (1)] screen.