Measurements
R&S
®
RTB2000
109User Manual 1333.1611.02 ─ 04
7.3.1 Cursor Settings
► To open the "Cursor" menu:
a)
Tap the
"Menu" icon in the lower right corner of the screen.
b) Scroll down. Select "Cursor".
Cursor
Activates or deactivates the cursor measurement.
Remote command:
CURSor<m>:STATe on page 317
Type
Selects the cursor type. Depending on the type, different results are displayed in the
result line at the bottom of the display.
The cursor lines can be set to the required position using the "Navigation" rotary knob,
or by dragging a cursor line on the screen.
"Horizontal"
Sets two horizontal cursor lines and measures the voltage values at
the cursor positions, and the difference between the cursor lines.
Results: V1, V2, ΔV (for current measurements: A1, A2, ΔA, for FFT
measurements: L in dBm)
"Vertical"
Sets two vertical cursor lines and measures the time from the trigger
point to each cursor line, the time between the cursor lines and the
frequency calculated from that time.
Results: t1, t2, Δt, 1/Δt (for FFT measurements: frequencies)
Cursor Measurements
To Next Page
Loading...
