Rohde & Schwarz R&S RTB2004 - Search

Remote Control Commands
R&S
®
RTB2000
281User Manual 1333.1611.02 ─ 04
REFCurve<m>:HORizontal:POSition <Position>
Changes the horizontal position of the reference waveform independently of the chan-
nel waveform settings.
Suffix:
<m>
.
1..4
Selects the reference waveform.
Parameters:
<Position> Default unit: s
REFCurve<m>:HORizontal:SCALe <Scale>
Changes the horizontal scale (timebase) of the reference waveform independently of
the channel waveform settings.
Suffix:
<m>
.
1..4
Selects the reference waveform.
Parameters:
<Scale> Default unit: s/div
REFCurve<m>:VERTical:POSition <Position>
Changes the vertical position of the reference waveform.
Suffix:
<m>
.
1..4
Selects the reference waveform.
Parameters:
<Position> Default unit: div
REFCurve<m>:VERTical:SCALe <Scale>
Changes the vertical scale of the reference waveform.
Suffix:
<m>
.
1..4
Selects the reference waveform.
Parameters:
<Scale> Default unit: V/div
15.6.4 Search
● General Search Settings.......................................................................................282
● Edge Search Configuration...................................................................................284
● Width Search Configuration.................................................................................. 285
● Peak Search Configuration................................................................................... 286
Waveform Analysis