Rohde & Schwarz R&S RTB2004 - Edge Trigger

Trigger
R&S
®
RTB2000
58User Manual 1333.1611.02 ─ 04
5.4 Edge Trigger
The edge trigger is the most common trigger type. The trigger occurs when the signal
from the trigger source passes the trigger level in the specified direction (slope).
Figure 5-1: Edge trigger event with positive slope (rising edge)
► TRIGGER > "Trigger Type" = "Edge"
Slope.............................................................................................................................58
Trigger Level, Threshold............................................................................................... 58
Coupling........................................................................................................................59
HF Reject...................................................................................................................... 59
Noise Reject..................................................................................................................59
Slope
Sets the edge direction for the trigger. You can trigger on:
●
rising edge, that is a positive voltage change
●
falling edge, that is a negative voltage change
●
rising and falling edge. After starting an acquisition, the instrument triggers on
the first identified edge.
Remote command:
TRIGger:A:EDGE:SLOPe on page 268
Trigger Level, Threshold
Sets the voltage level or threshold for the trigger.
Edge Trigger