Rohde & Schwarz R&S RTB2004 - Vertical Settings

Remote Control Commands
R&S
®
RTB2000
252User Manual 1333.1611.02 ─ 04
Parameters:
<AcquisitionState> RUN | STOPping | COMPlete | BREak
RUN | STOP | COMPlete | BREak
RUN
Set: Starts the acquisition.
Read: The acquisition is running.
STOPping
Set: Stops the acquisition when it is finished.
Read: Acquisition is stopped.
COMPlete
Set: Not available.
Read: The current acquisition is finished and completed.
BREak
Set: Immediate interrupt of current acquisition.
Read: acquisition is finished but interrupted.
15.4.3 Vertical Settings
CHANnel<m>:STATe..................................................................................................... 252
CHANnel<m>:AON........................................................................................................ 253
CHANnel<m>:AOFF.......................................................................................................253
CHANnel<m>:SCALe..................................................................................................... 253
CHANnel<m>:RANGe.................................................................................................... 253
CHANnel<m>:OFFSet....................................................................................................254
CHANnel<m>:COUPling.................................................................................................254
CHANnel<m>:BANDwidth...............................................................................................254
CHANnel<m>:POLarity...................................................................................................255
CHANnel<m>:SKEW......................................................................................................255
CHANnel<m>:ZOFFset[:VALue]...................................................................................... 255
CHANnel<m>:OVERload................................................................................................ 256
CHANnel<m>:THReshold............................................................................................... 256
CHANnel<m>:THReshold:FINDlevel................................................................................256
CHANnel<m>:THReshold:HYSTeresis.............................................................................257
CHANnel<m>:LABel.......................................................................................................257
CHANnel<m>:LABel:STATe............................................................................................257
CHANnel<m>:STATe <State>
Switches the channel signal on or off.
Suffix:
<m>
.
1..4
Selects the input channel. The number of channels depends on
the instrument.
Parameters:
<State> ON | OFF
Waveform Setup