Rohde & Schwarz R&S RTB2004 - Automatic Measurements

Remote Control Commands
R&S
®
RTB2000
307User Manual 1333.1611.02 ─ 04
15.7.2 Automatic Measurements
15.7.2.1 Measurement Settings
MEASurement<m>[:ENABle]...........................................................................................307
MEASurement<m>:MAIN................................................................................................307
MEASurement<m>:SOURce...........................................................................................309
MEASurement<m>:DELay:SLOPe...................................................................................310
MEASurement<m>:STATistics[:ENABle].......................................................................... 310
MEASurement<m>:STATistics:RESet.............................................................................. 311
MEASurement<m>[:ENABle] <State>
Activates or deactivates the selected measurement.
Suffix:
<m>
.
1..4
Selects the measurement place.
Parameters:
<State> ON | OFF
*RST: OFF
MEASurement<m>:MAIN <MeasType>
Defines the measurement type to be performed on the selected source. To query the
results, use MEASurement<m>:RESult[:ACTual]?.
Suffix:
<m>
.
1..4
Selects the measurement.
Measurements