Rohde & Schwarz R&S RTB2004 - Parallel Bus Configuration; Parallel Buses

Logic Analyzer (Option R&S RTB-B1, MSO)
R&S
®
RTB2000
224User Manual 1333.1611.02 ─ 04
13.5 Parallel Buses
The R&S RTB2000 can display and decode up to 16 lines of a parallel bus. You can
assign the logic channels to the bus bits individually. To trigger on parallel buses, use
the pattern trigger.
See Chapter 5.7, "Pattern Trigger", on page 64.
● Parallel Bus Configuration.....................................................................................224
● Decode Results.....................................................................................................226
13.5.1 Parallel Bus Configuration
You can configure a parallel bus or a parallel clocked bus. For the parallel clocked bus,
a clock line and an optional chip select line are defined in addition to the other settings.
Access: PROTOCOL > "Bus Type" = "Parallel" / "Parallel Clocked" > "Configuration"
The following configuration menu opens:
Figure 13-1: Configuration menu Parallel bus
Parallel Buses