Rohde & Schwarz R&S RTB2004 - Arbitrary Setup Settings

Signal Generation (Option R&S RTB-B6)
R&S
®
RTB2000
233User Manual 1333.1611.02 ─ 04
Remote command:
WGENerator:MODulation:FM:DEViation on page 445
ASK Depth
Sets the modulation depth, the percentage of the amplitude range that is used for ASK
modulation.
Remote command:
WGENerator:MODulation:ASK:DEPTh on page 445
Polarity
Sets the polarity of the ramp function for AM and FM modulation.
Remote command:
WGENerator:MODulation:RAMP:POLarity on page 446
Hop. Frequency
Sets the second frequency of the FSK-modulated signal.
Remote command:
WGENerator:MODulation:FSK:HFREquency on page 445
FSK Rate
Sets the rate at which signal switches between the carrier frequency and the hopping
frequency.
Remote command:
WGENerator:MODulation:FSK:RATE on page 446
14.1.4 Arbitrary Setup Settings
Visible
Enables the display of the ARB waveform.
Source
Selects the arbitrary waveform source. You can load an existing file or load the current
oscilloscope waveform.
Remote command:
WGENerator:ARBitrary:SOURce on page 443
Copy
Loads the waveform from the selected "Signal source".
Remote command:
WGENerator:ARBitrary:UPDate on page 443
Load
Opens a file selection dialog box and loads the selected file. The instrument sup-
ports .trf and .csv file formats, the same formats like for reference waveforms.
Function Generator