Rohde & Schwarz R&S RTB2004 - Automatic Setup; Starting and Stopping Acquisition; Trg; Wai

Remote Control Commands
R&S
®
RTB2000
250User Manual 1333.1611.02 ─ 04
Usage: Query only
*TRG
Trigger
Triggers all actions waiting for a trigger event. In particular, *TRG generates a manual
trigger signal. This common command complements the commands of the TRIGger
subsystem.
Usage: Event
*WAI
Wait to continue
Prevents servicing of the subsequent commands until all preceding commands have
been executed and all signals have settled (see also command synchronization and
*OPC).
Usage:
Event
15.4 Waveform Setup
● Automatic Setup....................................................................................................250
● Starting and Stopping Acquisition......................................................................... 250
● Vertical Settings.................................................................................................... 252
● Probes...................................................................................................................258
● Horizontal Settings................................................................................................258
● Acquisition Settings...............................................................................................260
● Waveform Data..................................................................................................... 265
15.4.1 Automatic Setup
AUToscale
Performs an autoset process for analog channels: analyzes the enabled analog chan-
nel signals, and adjusts the horizontal, vertical, and trigger settings to display stable
waveforms
Usage:
Event
Asynchronous command
15.4.2 Starting and Stopping Acquisition
RUN............................................................................................................................. 251
RUNContinous...............................................................................................................251
Waveform Setup