Rohde & Schwarz R&S RTB2004 - Acquisition Settings

Remote Control Commands
R&S
®
RTB2000
260User Manual 1333.1611.02 ─ 04
Return values:
<HorizDivCount> Returns 12 divisions.
Usage: Query only
TIMebase:RATime?
Queries the real acquisition time used in the hardware. If FFT analysis is performed,
the value can differ from the adjusted acquisition time (TIMebase:ACQTime).
Return values:
<HWAcqTime> Range: Depends on various settings
Default unit: s
Usage: Query only
15.4.6 Acquisition Settings
ACQuire:POINts:AUTomatic............................................................................................260
ACQuire:POINts[:VALue]................................................................................................ 261
CHANnel<m>:TYPE.......................................................................................................261
ACQuire:TYPE.............................................................................................................. 262
CHANnel<m>:ARIThmetics.............................................................................................262
ACQuire:PEAKdetect..................................................................................................... 263
ACQuire:HRESolution.................................................................................................... 263
ACQuire:NSINgle:COUNt................................................................................................263
ACQuire:AVERage:COUNt............................................................................................. 263
ACQuire:AVERage:RESet.............................................................................................. 264
ACQuire:AVERage:COMPlete?....................................................................................... 264
TIMebase:ROLL:ENABle................................................................................................ 264
ACQuire:INTerpolate......................................................................................................264
ACQuire:POINts:ARATe?............................................................................................... 265
ACQuire:SRATe?...........................................................................................................265
ACQuire:POINts:AUTomatic <AutoRecordLength>
Enables or disables the automatic record length. The instrument sets a value that fits
to the selected timebase.
If you set a specific value with ACQuire:POINts[:VALue], the automatic assign-
ment of a record length is turned off.
Parameters:
<AutoRecordLength> ON | OFF
Waveform Setup