Rohde & Schwarz R&S RTB2004 - Pattern Generator

Remote Control Commands
R&S
®
RTB2000
447User Manual 1333.1611.02 ─ 04
WGENerator:SWEep:FEND <StopFrequency>
Sets the stop frequency of the sweep signal.
Parameters:
<StopFrequency>
WGENerator:SWEep:FSTart <StartFrequency>
Sets the start frequency of the sweep signal.
Parameters:
<StartFrequency>
WGENerator:SWEep:TIME <SweepTime>
Sets the duration of the sweep.
Parameters:
<SweepTime>
WGENerator:SWEep:TYPE <SweepType>
Sets the type of the sweep, a linear or logarithmic change of the frequency.
Parameters:
<SweepType> LINear | LOGarithmic
WGENerator:SWEep[:ENABle] <SweepEnable>
Enables or disables sweeping.
Parameters:
<SweepEnable> ON | OFF
15.13.2 Pattern Generator
PGENerator:FUNCtion................................................................................................... 448
PGENerator:PATTern:STATe..........................................................................................448
PGENerator:PATTern:STIMe.......................................................................................... 449
PGENerator:PATTern:PERiod.........................................................................................449
PGENerator:PATTern:FREQuency.................................................................................. 449
PGENerator:PATTern:ITIMe............................................................................................449
PGENerator:PATTern:BURSt:STATe...............................................................................449
PGENerator:PATTern:BURSt:NCYCle............................................................................. 450
PGENerator:PATTern:TRIGger:MODE.............................................................................450
PGENerator:PATTern:TRIGger:SINGle............................................................................ 450
PGENerator:PATTern:TRIGger:EXTern:SLOPe................................................................ 450
Signal Generation (Option R&S RTB-B6)