Rohde & Schwarz R&S RTB2004 - Mathematics

Remote Control Commands
R&S
®
RTB2000
277User Manual 1333.1611.02 ─ 04
TIMebase:ZOOM:POSition <Position>
Defines the position of the zoom window in the upper window.
Parameters:
<Position> Range: Depends on the zoom time base, from nearly 0 to
100 % for large zoom.
*RST: 50
Default unit: %
15.6.2 Mathematics
To get the data of a math waveform, use the following commands, which are described
in :
●
CALCulate:QMATh:DATA? on page 344
●
CALCulate:QMATh:DATA:HEADer? on page 344
●
CALCulate:QMATh:DATA:XINCrement? on page 347
●
CALCulate:QMATh:DATA:XORigin? on page 347
●
CALCulate:QMATh:DATA:YINCrement? on page 348
●
CALCulate:QMATh:DATA:YORigin? on page 348
●
CALCulate:QMATh:DATA:YRESolution? on page 349
CALCulate:QMATH:STATe.............................................................................................277
CALCulate:QMATh:SOURce<m>.................................................................................... 277
CALCulate:QMATh:OPERation....................................................................................... 278
CALCulate:QMATh:POSition...........................................................................................278
CALCulate:QMATh:SCALe............................................................................................. 278
CALCulate:QMATH:STATe <State>
Activates the mathematics function and displays the resulting math waveform.
Parameters:
<State> ON | OFF
CALCulate:QMATh:SOURce<m> <Source>
Defines the first and the second source for the mathematical operation (operands). The
sources can be any active analog channel.
Suffix:
<m>
.
1..2
Selects the source.
Parameters:
<Source> CH1 | CH2 | CH3 | CH4
Example:
CALC:QMAT:SOUR1 CH2
CALC:QMAT:SOUR2 CH1
Waveform Analysis