Rohde & Schwarz R&S RTB2004 - Measurements; Quick Measurements

Remote Control Commands
R&S
®
RTB2000
306User Manual 1333.1611.02 ─ 04
15.7 Measurements
15.7.1 Quick Measurements
In the quick measurement commands, the numeric suffix <m> is irrelevant, omit it.
MEASurement<m>:AON.................................................................................................306
MEASurement<m>:AOFF............................................................................................... 306
MEASurement<m>:ARESult?..........................................................................................306
MEASurement<m>:ALL[:STATe]..................................................................................... 306
MEASurement<m>:AON
Starts the quick measurement.
Usage:
Event
MEASurement<m>:AOFF
Stops the quick measurement.
Usage:
Event
MEASurement<m>:ARESult?
Returns the results of the quick measurement.
Return values:
<Data> List of values
Quick measurement results are listed in the following order:
PEAK (Vpp), UPE (Vp+), LPE (Vp-), CYCR (RMS-Cyc), CYCM
(MeanCyc), PER (T), FREQ (f), RTIM (tr), FTIM (tf).
Usage: Query only
MEASurement<m>:ALL[:STATe]
Starts or stops the quick measurement and sets the status bit.
Suffix:
<m>
.
1..4
The suffix is irrelevant.
Parameters:
<State> ON | OFF
*RST: OFF
Measurements