Rohde & Schwarz R&S RTB2004 - Asynchronous Command; Run; Runcontinous; Usage: Event

Remote Control Commands
R&S
®
RTB2000
251User Manual 1333.1611.02 ─ 04
SINGle..........................................................................................................................251
RUNSingle.................................................................................................................... 251
ACQuire:NSINgle:COUNt................................................................................................251
STOP........................................................................................................................... 251
ACQuire:STATe.............................................................................................................251
RUN
RUNContinous
Starts the continuous acquisition.
Usage: Event
Asynchronous command
SINGle
RUNSingle
Starts a defined number of acquisitions. The number of acquisitions is set with
ACQuire:NSINgle:COUNt.
Usage:
Event
Asynchronous command
ACQuire:NSINgle:COUNt <NSingleCount>
Sets the number of waveforms acquired with RUNSingle.
Parameters:
<NSingleCount> Number of waveforms.
Range: 1 to maximum number that depends on the record
length.
*RST: 1
STOP
Stops the running acquistion.
Usage:
Event
Asynchronous command
ACQuire:STATe
Sets or queries the acquisition state of the instrument.
Waveform Setup