Rohde & Schwarz R&S RTB2004 - Runt Search Configuration

Remote Control Commands
R&S
®
RTB2000
288User Manual 1333.1611.02 ─ 04
To set the range ± Δt, use SEARch:TRIGger:RISetime:DELTa.
Parameters:
<Range> LONGer | SHORter | WITHin | OUTSide
LONGer
Finds rise/fall times longer than the given time.
SHORter
Finds rise/fall times shorter than the given time.
WITHin
Finds rise/fall times inside the range time ± Δt.
OUTSide
Finds rise/fall times outside the range time ± Δt.
*RST: LONG
SEARch:TRIGger:RISetime:TIME
<Time>
Sets the reference rise or fall time, the nominal value for comparisons.
Parameters:
<Time> Range: Depends on various settings, mainly time base and
sample rate
*RST: 400e-6
Default unit: s
SEARch:TRIGger:RISetime:DELTa <DeltaTime>
Sets a range Δt to the reference rise/fall time set with SEARch:TRIGger:RISetime:
TIME, if SEARch:TRIGger:RISetime:RANGe is set to Within or Outside. The
instrument finds rise/fall times inside or outside the range time ± Δt.
Parameters:
<DeltaTime> Range: Depends on various settings, mainly time base and
sample rate
*RST: 100e-6
Default unit: s
15.6.4.6 Runt Search Configuration
SEARch:TRIGger:RUNT:POLarity................................................................................... 288
SEARch:TRIGger:LEVel:RUNT:LOWer............................................................................ 289
SEARch:TRIGger:LEVel:RUNT:UPPer.............................................................................289
SEARch:TRIGger:RUNT:RANGe.....................................................................................289
SEARch:TRIGger:RUNT:WIDTh......................................................................................289
SEARch:TRIGger:RUNT:DELTa......................................................................................290
SEARch:TRIGger:RUNT:POLarity <Polarity>
Indicates the polarity of a the runt to be searched for.
Waveform Analysis